Muton XPJ-1641SR - Setup 7: Method of Cut

Setup 7: Method of Cut 79
When the “Output Mode” is set to “Off” or “Auto Cut”
Sets the ink drying time.
Use or to enter the value, and tap [Enter].
Setting values
<0 sec> to 60 min
<> indicates the initial value.
Setup 7: Method of Cut
Sets the media cutting operation after printing.
Setting values
Cut with fewer steps than “Single Cut - 3
steps”.
Suitable for media with narrow width.
Normal cutting method.
This is the initially set value.
Set when unable to cut with “Single Cut -
2 steps”.
Suitable for media with narrow width.
Set when unable to cut with “Single Cut -
3 steps”.
Note
• When the media detection is set to “Off”, the media cannot be cut automatically.
"Setup 4: Media Initial" P. 77
• Some media may not be cut (cannot be cut at all or cannot be cut finely). In such a case, set the “Output Mode menu” to “Off” and cut the
media manually.
"Setup 6: Output Mode" P. 78
Cut Pressure menu
Sets the media cutting pressure for the cutting operation.
Setting values
Cut the media at low pressure.
Suitable for thin media or if the “High”
pressure setting is too strong.
Normal cutting pressure.
This is the initially set value.
Output Mode:
Off
Output Mode:
Auto Cut
InkDryTimer:
(0 sec - 60 min) 0 sec
Setup 7
Method of Cut
Method of Cut:
Single Cut - 2 steps
Method of Cut:
Single Cut - 3 steps
Method of Cut:
Double Cut - 2 steps
Method of Cut:
Double Cut - 3 steps
Method of Cut:
Single Cut - 3 steps
Cut Pressure:
Low
Cut Pressure:
High