Muton XPJ-1641SR - Setup 21: Initialization; Setup 22: Life Times

88 Setup 21: Initialization
Setup 21: Initialization
Restore the printer settings to the factory default.
Setting values
For initializing the settings of all the
menus.
Initializes the settings in the User Type
menu.
Initializes the settings other than the ones
in the User Type menu.
Setup 22: Life Times
Displays the operational life time of each part.
• The lifetime of each part is indicated by the asterisks (Maximum 5 asterisks: 100% left).
As the part deteriorates, the number of asterisks decreases one by one (20%).
• The part should be changed when all of the asterisks have disappeared and “Change”
is displayed.
Contact your local MUTOH dealer to ask for replacing parts.
• After “Change” appears, “Life Times [Pump *]” or a similar message will be displayed
when you are not in this menu.
You can delete this message by pressing the [Cancel] key.
The below is an example when using XPJ-1682SR.
Displays the service life for the print head
1.
The service life in this case is at 60%.
Displays the service life for the print head
2.
The service life in this case is at 60%.
Displays the service life for the pump 1.
The service life in this case is at 60%.
Displays the service life for the pump 2.
The service life in this case is at 60%.
Displays the service life for the CR motor.
The service life of the component in this
case is over.
Have the component replaced.
Displays the service life for the PF motor.
The service life in this case is at 80%.
Setup 21
Initialization
Initialization:
ALL
Initialization:
UserType
Initialization:
Except UserType
Setup 22
Life Times
Life Times
Head1: E*** F
Life Times
Head2: E*** F
Life Times
Pump1: E*** F
Life Times
Pump2: E*** F
Life Times
CR Motor: Change
Life Times
PF motor: E**** F