146 Status messages
4 Messages and Error Message s
This section describes messages displayed during normal printer operation or when errors occur, and solutions to the messages.
This section describes messages displayed during printer normal operation.
When the product is operating correctly, each operation status is displayed on the front panel as below.
Status messages
Display Description
Ready to Print
PG: Low W: XXXX mm
Standby (Media is loaded).
Media End
PG: Low
Standby (Media is not loaded).
"Loading a roll media" P. 22
Receiving
PG: Low W: XXXX mm
Receiving data.
Converting
PG: Low W: XXXX mm
Analyzing data.
Printing
PG: Low W: XXXX mm
Under printing.
Remain: XXX.Xm Displays the length of the data that has not been printed in meters for the
data currently being printed.
Remain Time: XXX.Xmin Displays the time remaining to print in minutes for the data currently being
printed.
Media Remain: XXX m Displays the remaining length of the media currently set in meters.
Pausing Print
Cancel Print -> Enter
Pausing printing.
• Tap [Cancel] to resume printing.
• Tap [Enter] to cancel the print job.
Warming Up Warming up Heater.
Warming Up
Skip -> Enter
Received the printing data while Heater is warming up.
To start printing before Heater is warmed up, press the [Enter] key.
Cleaning **% Cleaning.
Please wait a while.
Ink Refill **% Charging the ink.
Please wait a while.
SubTank Refill **% Charging the subtank.
Please wait a while.
Busy-Washing • Initial charging, ejecting filler fluid.
• Washing the print head by cleaning fluid.
Please wait a while.
During discharge Flushing ink from the print head in the head cleaning process.
Please wait a while.
Messages and Error Messages
To Next Page
Loading...
