148 Error message display and remedies
This section describes error messages and remedies.
Error messages are displayed when certain failures occur during printer operation.
If an error that can be displayed occurs, the printer may display the following error messages on the front panel and stop
operation.
Error message display and remedies
Display Description
Cover Open Any or all of covers (front cover, maintenance cover right, maintenance cover
left) are open.
Close the cover.
Put Lever Back The pressure rollers is released. Lower the pressure rollers.
Hold Media The media is not loaded.
Load the media.
"Loading a roll media" P. 22
Undefined Media Media detection has failed. (Stops operation)
Reload the media.
Media Slant Media is fed obliquely. (Stops operation)
Reload the media.
Media Cut Error The media was not cut. (Stops operation)
Change Head Gap ***
PG: *** W: ****mm
The head height on the printer does not match with the one specified on the
print data.
"Changing the Head Height" P. 40
End Of Roll The Media has run out. (Stops operation)
Load a new media.
"Loading a roll media" P. 22
[******] Ink End Ink has run out. (Stops operation)
Replace with a new ink bag.
"Replacing ink bag" P. 112
[******] No Bag Ink bag case is not inserted. (Stops operation)
Insert Ink bag case.
[******] No S/C Card S/C card is not inserted. (Stops operation)
Insert S/C card.
[*] S/C Ink Low Slot * ink is low.
Get a replacement bag ready.
[******] S/C Ink End Ink has run out. (Stops operation)
Replace with a new ink bag.
"Replacing ink bag" P. 112
[*******] Discharged Ink is not filled.
Perform initial ink charging.
"Performing initial charging after head cleaning" P. 142
Full WasteInkTank The waste ink tank is full. (Stops operation)
Immediately empty the tank.
"Emptying waste ink tank" P. 115
To Next Page
Loading...
