Is holddown pressure adequate for the roll media?
- Use the slide lock lever on the individual pressure rollers to reduce or cancel the
pressure.
Is the media loaded correctly?
‐ Load the media correctly.
Are any curls or warps present on your media?
‐ Set the edge holder at both edges of the media.
‐ Check that you select the appropriate vacuum fan setting.
Are you using creased, damaged, torn or curled media?
‐ Replace the media.
Is the media loaded correctly?
‐ Load the media correctly.
Is the media loaded at an angle?
‐ Load the media straight.
Did you load the media which has been printed before?
‐ Use a new media.
The printer does not detect
the media.
Do you use the printer within recommended environmental conditions?
- Make sure to use the printer within the specification range.
Are there any foreign materials such as torn paper attached to Pressure
rollers?
- Clean Pressure rollers.
Do you use the printer within recommended environmental conditions?
- Make sure to use the printer within the specification range.
Note
To Next Page
Loading...
