154 Media-related troubleshooting
“Ensuring a suitable place for installation” of the “Startup Guide”, "After loading the media..." P. 29, "**>7: Vacuum Fan" P. 74,
"The media is jammed" P. 158, "Loading a roll media" P. 22
Media jams frequently occur.
Are any curls or warps present on your media?
‐ Set the edge holder at both edges of the media.
‐ Check that you select the appropriate vacuum fan setting.
Are you using creased, damaged, torn or curled media?
‐ Replace the media.
Is the media loaded correctly?
‐ Load the media correctly.
The media skews during
printing.
Do you use the printer within recommended environmental conditions?
- Make sure to use the printer within the specification range.
Note
If the media is jammed or torn, remove it according to "The media is jammed" P. 158
To Next Page
Loading...
