Muton XPJ-1641SR - Page 74

74 Setup 1: User Type
**>4: Pre Heater
Sets up Pre Heater.
Use or to enter the value, and tap [Enter].
Setting values
Off / <30°C> to 50 °C
<> indicates the initial value.
**>5: Platen Heater
Sets up Platen Heater.
Use or to enter the value, and tap [Enter].
Setting values
Off / <30°C> to 50 °C
<> indicates the initial value.
**>6: Dryer
Sets up Dryer.
Use or to enter the value, and tap [Enter].
Setting values
Off / <30°C> to 50 °C
<> indicates the initial value.
**>7: Vacuum Fan
Selects the vacuum level.
Use or to select the value, and tap [Enter].
• If you are using a thin or delicate media and there is risk of it wrinkling due to the fan,
set a lower value for the fan.
Setting values
Low / Medium / <High>
<> indicates the initial value.
Type ** : 4
Pre Heater
** : Pre Heater :
(30 - 50) 30 C
Type ** : 5
Platen Heater
** : Platen Heater :
(30 - 50) 30 C
Type ** : 6
Dryer
** : Dryer :
(30 - 50) 30 C
Type ** : 7
Vacuum Fan
** : Vacuum Fan :
High