Setup 1: User Type 73
PF Adjust 4: Micro Print
• Observe the pattern and verify the micro adjustment value. In the pattern, look for a place that has least white lines or
overlapping in images. The number printed below the pattern is the micro adjustment value.
Enter the micro adjustment value according to the print result.
PF Adjust 5: Micro Change
Performs Micro adjustment Print.
Enter the appropriate micro adjustment value according to the print result.
Note
Once an appropriate micro adjustment value has been saved, the value will be the baseline value from the next time to be printed in the
center of the pattern.
For example, if you have entered “-0.20” and print a micro adjustment pattern, values printed below block pattern will be changed to (from
left) +1.00, +0.60, +0.30, 0.00, -0.20 (baseline value), -0.30, -0.40, -0.70, -1.00, -1.40.
Use or to enter the adjustment value, and tap [Enter].
Select whether you wish to perform confirmation print and complete the setup.
Setting values
-5.00% to <0.00%> to 5.00%
<> indicates the initial value.
** : PF Adjust 4
Micro Print
-0.50-0.20-0.100.00+0.10+0.20+0.50
+0.80+1.20
-0.80 -1.20
Micro Adjustment Value
-0.50-0.10 -0.20
Not Adequate Not AdequateAdequate
** : PF Adjust 5
Micro Change
** : Micro :
(-5 - 5) 0.00%
To Next Page
Loading...
