Muton XPJ-1641SR - Setup 16: Ink Status; Setup 17: Roll Length

Setup 16: Ink Status 85
When the “Roll Kind” is set to “Roll 1”, “Roll 2” or “Roll 3”
Setup 16: Ink Status
Displays the percentage of ink level in each ink bag.
To identify the ink slots corresponding to the numbers shown here, see "Main
components of your printer" P. 9.
The below is an example when using XPJ-1682SR.
Note
To display various information of Ink, use genuine ink and S/C cards.
If Ink bags other than genuine Ink bags are used, ink status will not be displayed correctly.
Setup 17: Roll Length
Sets up the media length.
Setting values
Roll Length is not used.
This is the initially set value.
Sets up the media length.
The set values of the media length can be
set as “Roll1” to “Roll3”.
Length menu
Sets up the media length.
Setting values
1 m to <30 m> to 1,500 m
<> indicates the initial value.
Setup 16
Ink Status
1 2 3 4 : 100 / 90 / 90 / 80
5 6 7 8 : 100 / 90 / 90 / 80
Setup 17
Roll Length
Roll Kind:
Off
Roll Kind:
Roll *
Roll Kind:
Roll 1
Length:
(1 - 1500) 30 m