104 Display 3: Length
4Menu 8: Job Status
Display 3: Length
Choose the unit of the length displayed on the operation panel.
Setting values
Displays the length in millimeters (mm).
This is the initially set value.
Displays the length in inches (inch).
Various information of previous print will be displayed.
Displays if the print is completed.
• When the print is completed: [Completed]
• When the print is canceled: [Canceled]
The total length of print data (media
feeding direction) will be displayed.
The printed length will be displayed.
The remaining length of print data will be
displayed.
Note
• The values displayed in this function are just standard values, not guarantee the accuracy.
• If the print data includes no length data, all information will be displayed as “0”.
• This function is to check the information of print data with the print operation is completed. For the details on data while printing, please
refer to the "Menu 7: Job Status" P. 51.
Job Status
Status: Completed
Job Status
ToDoLength: XXX.X m
Job Status
Remain: XXX.X m
To Next Page
Loading...
