120 Cleaning of cleaning wiper
Cleaning period:
•Weekly
• When print blurring and dot missing remain after head cleaning is done.
Preparation:
• Cleaning stick
Cleaning of cleaning wiper
Important!
During cleaning, please note the followings.
• If it is hard to remove the stain, perform “Short” Head cleaning, and then clean again.
• Use a dry cleaning stick. A damp stick can cause damage to the print head.
• Do not touch the tip of a cleaning stick with fingers. Skin oil will damage the print head.
• Do not reuse a cleaning stick. Dust on the stick will damage the print head.
• This cleaning takes about 5 minutes. If it takes longer, the stick will get dry causing damage to the print head.
1. Putting the printer into the CR maintenance mode
[1]
Tap [Home].
[2]
Tap .
[3]
Tap until the menu on the left appears.
•Tap .
To Next Page
Loading...
