Head cleaning 119
[4]
Check the print result.
• If you find missing or thin lines on the print, go to "Performing Head cleaning" P. 118.
• If all lines are clearly printed, you can start printing.
Note
• The pattern shown above is an example when printed on XPJ-1682SR with 4-color configuration.
• If nozzle missing persists after repeating normal cleaning several times, perform Long cleaning.
• If several Long cleaning does not help to recover nozzles, perform
"Cleaning of cleaning wiper" P. 120 or "Cleaning around the print head"
P. 125
.
• If nozzle missing still persists, perform Little Charge from “Menu 3 Cleaning” > “Select Print Head” > “Cleaning Type”.
"Menu3: Cleaning" P. 99
To Next Page
Loading...
