Setup 1: User Type 75
**>8: Thickness
Sets the thickness of the media you are using.
Use or to enter the value, and tap [Enter].
Setting values
80 μm to <170 μm> to 2,800 μm
<> indicates the initial value.
Note
• This menu is to automatically adjust print quality to a certain extent. If you want to improve print quality, manually adjust it.
"**>2: Adjust Print>" P. 63
• If you have adjusted the print settings, you do not need to configure the thickness of the media in this menu.
**>9: Copy User Type
This is for copying the currently selected User Type setting into another User
Type.
The items that will be copied are:
• “Print Mode”, “Effect”
• The adjustment value for “Adjust Print”, “PF Adjust”
• The setting value for “Pre Heater”, “Platen Heater”, “Dryer”, “Vacuum Fan”, and
“Thickness”
Setting values
Here you can select the User Type to copy
the settings into.
If you select ALL, the settings will be
copied into all the User Type.
Type ** : 9
Copy User Type
** : UserCopy :
Type ** -> 1
** : UserCopy :
Type ** -> ALL
To Next Page
Loading...
