Muton XPJ-1641SR - Page 63

Setup 1: User Type 63
Adjust Print 1: Standard
**>2: Adjust Print>
Sets up when adjusting the printer for the optimum quality of image print.
Before adjusting this setting, enter the thickness of the media.
Submenus
Adjusts only the print mode in the user
type setting which is currently set.
Adjusts the print modes other than the
mode in the user type setting which is
currently set.
Perform an automatic calibration that the
printer automatically prints and scans a
pattern with the embedded color sensor
to correct dot placement.
Adjusts only the print mode in the user type setting which is currently set.

"Confirm pattern" P. 66
"Rough adjustment pattern" P. 67
"Fine adjustment pattern" P. 67
Submenus
Print the test pattern for the adjustment.
Check before adjusting.
Perform this to adjust large misalignment.
Print Adjust pattern and enter the set
value.
Perform this to adjust small misalignment.
Print Adjust pattern and enter the set
value.
Type ** : 2
Adjust Print
** : Adjust Print 1
Standard
** : Adjust Print 2
Custom
** : Adjust Print 3
Auto
** : Adjust Print 1
Standard
** : Standard 1
Confirm Pattern
** : Standard 2
Rough Pattern
** : Standard 3
Fine Pattern