NAiS GT Series - COM. Port Wiring Instructions; Chapter 6: How the Various Functions Are Used; Screen Switching Operations; GT01 Basic Communication Area and Bit Devices

6 How the Various Functions Are Used 6-1
6.1 Switching Screens 6-2
6.1.1 Switching the Screen from the PLC 6-2
6.1.2 Switching the Screen with the GT Main Unit 6-3
6.2 Basic Communication Area to PLC and Bit Device Functions (GT01) 6-6
6.3 Basic Communication Area to PLC and Bit Device Functions (GT11) 6-7
6.4 Basic Communication Area to PLC and Bit Device Functions (GT30) 6-9
7 Servicing and Maintenance 7-1
7.1 What the Battery Does (GT11) 7-2
7.2 What the Battery Does (GT30) 7-3
7.3 About the Front Panel Protective Sheet 7-4
7.4 About the Waterproof Packing 7-5
7.5 Replacing the Backlight (Sold Separately) (Applies Only to GT30) 7-6
8 Troubleshooting 8-1
8.1 What to DO If Something Unusual Occurs (GT01 & GT11) 8-2
8.2 What to DO If Something Unusual Occurs (GT30) 8-5
8.3 Error Codes and How to Handle Them 8-8
8.3.1 About Error Codes 8-8
8.3.2 GT Weries Error Codes 8-8
8.3.3 When Connected to a FP Series PLC 8-9
8.3.4 When Connected to a PLC (FX Series) Made by Mitsubishi Electric Corporation 8-10
8.3.5 When Connected to a PLC Made by Omron Corporation 8-10
8.4 Table of Screen Messages 8-11
9 Documentation 9-1
9.1 BIN/HEX/BCD Code Correspondence Table 9-2
9.2 ASCII Code Table 9-3
9.3 Cable Specifications 9-4
9.3.1 FP series TOOL Port Connection Cable: Mini-DIN 5-pin Loose Wire (AIGT8142) 9-4
9.3.2 Mitsubishi Electric FX series TOOL Port Communication Cable (AIGT8152) 9-4
9.3.3 PLC Communication Cable: Mini-DIN 5-pin Loose Wire (AIGT816*) 9-4
9.3.4 PLC Communication Cable: Mini-DIN 8-pin Loose Wire (AIGT8175) 9-5