Name: Napoleon Vector Series
Brand: Napoleon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

W415-2034 / A / 10.18.19

general information

Safety Barrier

1.2 installation overview

Recommended installation steps:

1. Determine venting requirements before deciding the ﬁ nal location of the appliance.

2. Plan out appliance enclosure, framing, fronts, accessories, etc.

3. Install rough framing (refer to “rough framing” section).

4. Place the appliance in its ﬁ nal position.

5. Install nailing tabs (refer to “nailing tab installation” section).

6. Install appliance venting (refer to “venting installation” section).

7. Install vent shield (refer to “vent shield installation” section).

8. Install all electrical wirings (refer to “electrical information” section).

9. Install gas lines (refer to “gas installation” section).

10. Test appliance.

11. Complete framing (refer to “ﬁ nish framing” section).

12. Finishing (refer to “ﬁ nishing” section).

13. Complete installation checklist in the owner’s manual and apply serial number to owner’s manual.

For Dynamic Heat Control™ installation steps, refer to the leaﬂ et provided with the Dynamic Heat Control™ kit.

Start Dynamic Heat Control™ installation before step 3 (place the appliance in its ﬁ nal position)

note:

Other manuals for Napoleon Vector Series

Questions and Answers:

Need help?

Do you have a question about the Napoleon Vector Series and is the answer not in the manual?

General