5. RAID System Configuration
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
110
Chapter 2 Useful Features
5.3.2
Executing rebuilding manually
Replace the hard disk drive
Run the LSI Software RAID Configuration Utility
Execute rebuilding
Exit the LSI Software RAID Configuration Utility
1. Replace the hard disk drive and turn on the server.
2. Run the LSI Software RAID Configuration Utility.
3. Select Rebuild from the TOP menu.
The Rebuild - PHYSICAL DRIVES SELECTION MENU screen appears.
4. Move the cursor to a hard disk drive indicated by "FAIL", and then press the space key to select it.
The "FAIL" of the selected drive turns pink.
5. Press <F10> key after selecting the hard disk drive.
6. To start the rebuilding the selected drive, choose Yes at the confirmation message.
Rebuilding completes when the "Completed" progress bar on the REBUILDING screen reaches 100%.
7. Press <Esc> key to return to the TOP menu screen, and then exit the LSI Software RAID Configuration
Utility.
ONLINE A00-00
FAIL A00-01
PORT #
0
1
Rebuild – PHYSICAL DRIVES SELECTION MENU
To Next Page
Loading...
