7. Resetting and Clearing the Server
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
43
Chapter 1 Maintenance
7.3
Forced Shutdown
Use this feature when an OS command does not shut down the server, POWER Switch does not turn off the
server, or software reset does not work.
Continue to hold POWER Switch of the server for at least four seconds. The power is forcibly turned off. To
turn on the power back again, wait at least 30 seconds after turning off the power.
Note
If the remote power-on feature is used, cycle the power once to load the OS after
the power has been forcibly turned off, and then turn off the power again by
shutting down the OS.
<Express5800/T110f-S>
<Express5800/R110f-1E>
3.5-inch Hard Disk Drive model
2.5-inch Hard Disk Drive model
POWER Switch
(Keep pressing for at least four seconds)
POWER Switch
(Keep pressing for at least four seconds)
POWER Switch
Kee
ressin
for at least fou
seconds
To Next Page
Loading...
Need help?
General