EasyManuals Logo

NEC Express 5800 Series Maintenance Guide

NEC Express 5800 Series
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
5. Troubleshooting
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
32
Chapter 1 Maintenance
Is a cartridge inserted into built-in RDX (USB)?
Either remove the cartridge or change the boot order in BIOS Setup.
Is Disk Array unit connected to the PCI card?
Change the boot device configuration from HDD Drive BBS Priorities of the BIOS Setup Boot menu.
[?] The following message appears when logging in the system on Windows Server 2008 R2 or Windows
Server 2008:
Have you finished license authentication for Windows product?
The above message will appear if you use Windows Server 2008 R2 or Windows Server 2008 with the
unauthenticated license.
Select [Get Genuine now] and proceed license authentication.
The above message is an example of request for license authentication. The message displayed on
screen may differ from this depending on the license.
5.5
Problem of Windows STOP Error
[?] Cannot turn the power OFF at the blue screen (STOP error screen)
If you want to turn off the power at the blue screen, execute forced shutdown (continue to press the
power switch for 4 seconds). If you press the switch briefly instead of holding it, the server will not power
off.

Table of Contents

Other manuals for NEC Express 5800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC Express 5800 Series and is the answer not in the manual?

NEC Express 5800 Series Specifications

General IconGeneral
BrandNEC
ModelExpress 5800 Series
CategoryServer
LanguageEnglish

Related product manuals