7. Resetting and Clearing the Server
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
45
Chapter 1 Maintenance
7.4
Clearing BIOS Settings (CMOS Memory)
To set the BIOS settings back to the factory settings (clearing CMOS memory), use the internal jumper switch.
You can also clear the password in BIOS Setup Utility (SETUP) by using the same procedure.
Tips
Use BIOS Setup Utility (SETUP) usually to return the settings to the factory
defaults.
To clear the password or the CMOS memory, use the corresponding jumper switch illustrated in the figure
below.
Important
Do not change any other jumper switch settings. Any change may cause the
server to fail or malfunction.
3 2 1
Clear
Keep (factory setting)
3 2 1
Clear
Keep (factory setting)
Clear Password Jumper
(J_PASSWORD)
Clear CMOS Jumper
(J_CLRCMOS)
To Next Page
Loading...
Need help?
General