9. Offline Tools
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
53
Chapter 1 Maintenance
9.3
Console-less Feature
The Off-line tools can be remotely controlled from PC for Management without a keyboard or other consoles.
9.3.1
How to remotely control
Control from a LAN connected PC for Management using the remote KVM of EXPRESSSCOPE engine 3.
For details of the remote KVM, see "EXPRESSSCOPE Engine 3 User’s Guide" in EXPRESSBUILDER.
Note
Connect the LAN cable to the connector on management LAN port. Or, if Shared
BMC LAN feature is used, connect the LAN cable to the corresponding LAN
connector.
You can also control Off-line Tools remotely by using BIOS Console Redirection.
9.3.2
Preparation
Set the remote management feature of EXPRESSSCOPE Engine 3 in advance to check hardware error
information during console-less operation.
For settings information, see "EXPRESSSCOPE Engine 3 User's Guide" or NEC ESMPRO Manager online
help.
To Next Page
Loading...
Need help?
General