5. Troubleshooting
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
39
Chapter 1 Maintenance
5.11
Problem of Optical Disk Drive
[?] Unable to access or play a disc
Is the disc properly set in the optical disk drive tray?
→ There is a holder in the tray to secure the disc. Make sure that the disc is securely placed in the holder.
[?] Unable to access or play DVD/CD-ROMs
Is the DVD/CD-ROM supported by the server?
→ For a disc such as a CD with copy guard which does not conform to the CD standard, the playback of
such a disk with the optical disk drive is not supported.
→ The DVD/CD-ROM for Macintosh is not supported.
[?] Unable to eject a disc using the eject button
→ Eject the disc in the following procedure.
1. Press POWER Switch to turn off the server (POWER LED is off).
2. Use a 100 mm long metal pin that
is 1.2 mm in diameter (or uncoil a
thick paper clip) and insert it into
the eject hole at the front of the
tray. Keep pressing slowly until the
tray comes out.
Important
• Do not use anything that easily breaks such as toothpicks or plastic.
• If you still cannot eject the disk, contact your sales representative.
3. Pull the tray out with your hands.
4. Remove the disc.
5. Push the tray back.
5.12
Problem of Powering Off
[?] The power is not turned off
Is the suppression feature of the power switch enabled?
→ Restart the system once and start the BIOS setup utility.
The menu to be confirmed: Server → Power Switch Inhibit
Eject hole
To Next Page
Loading...
Need help?
General