EasyManuals Logo

NEC Express 5800 Series Maintenance Guide

NEC Express 5800 Series
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
7. Resetting and Clearing the Server
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
46
Chapter 1 Maintenance
The following instructions show how to clear the CMOS memory and the password.
WARNING
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, refer to
Safety precautions in Precautions for Use in "User’s Guide".
Do not disassemble, repair, or alter the server.
Do not remove lithium, NiMH, or Li-ion batteries.
Disconnect the power plug before installing or removing the server.
CAUTION
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety precautions in Precautions for Use in "User’s Guide".
Make sure to complete installation.
Do not get your fingers caught.
Avoid installing under extreme temperature conditions.
Important
Take anti-static measures before operating the server. For detailed
information on static electricity, see Chapter 2 (1.2 Anti-static Measures) in
"User's Guide".
Clearing CMOS memory
1. See "Getting Started" attached to this server or Chapter 2 (1. Installing Internal Optional Devices) in
"User’s Guide" to remove Top Cover.
2. Confirm the position of Clear CMOS Jumper.
3. Change the jumper from Keep to Clear.
4. Wait at least five seconds and then return the jumper to Keep.
5. Assemble the removed components.
6. Plug in the power cord and turn on the server.
7. POST halts with the following error massage.
ERROR
8006: System configuration data cleared by Jumper.
Press <F1> to resume, <F2> to Setup
8. Press <F2> key to start BIOS Setup Utility, and then run Load Setup Defaults from Save & Exit menu.
The server will restart once before the OS starts.
Tips
After this operation, system may restart once before the OS is started.

Table of Contents

Other manuals for NEC Express 5800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC Express 5800 Series and is the answer not in the manual?

NEC Express 5800 Series Specifications

General IconGeneral
BrandNEC
ModelExpress 5800 Series
CategoryServer
LanguageEnglish

Related product manuals