5. Troubleshooting
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
27
Chapter 1 Maintenance
[?] POST does not complete
Is memory installed correctly?
→ Check if memory is installed correctly.
Is the memory size large?
→ The memory check may take longer than usual if the installed memory size is large. Wait for a while.
Did you perform any keyboard or mouse operation immediately after you started the server?
→ If you perform any keyboard or mouse operation immediately after start-up, POST may accidentally
detect a keyboard controller error and stops processing. In such a case, reboot the server. Do not
perform any keyboard or mouse operation until the BIOS start-up message appears after you reboot the
server.
Are memory and PCI devices supported for use with this server?
→ Operation of the server with unauthorized devices is not guaranteed.
[?] The POST error message “B000: Expansion ROM not initialized” is output when an optional card is
installed.
Check if expanding the option ROM of a device other than the boot device is enabled.
Start the BIOS setup utility and set expansion of the option ROM of a device other than the boot device to
Disabled.
Advanced → PCI Configuration → PCI Slot n Option ROM → Enabled
Advanced → PCI Configuration → LAN1 Option ROM Scan → Disabled
To Next Page
Loading...
Need help?
General