221
you want to apply the changes and reset iLO.
4. If iLO prompted you to confirm a settings change and reset, click OK to end your browser
connection and reset iLO.
Access options
You can configure the following settings in the Access Options section on the Access Settings
page.
Idle Connection Timeout (minutes)
Specifies how long a user can be inactive before an iLO web interface or Remote Console
session ends automatically.
The iLO web interface and the Remote Console track idle time separately because each
connection is a separate session. This setting has no effect on a Remote Console session if a
Virtual Media device is connected.
The following values are valid:
• 15, 30, 60, or 120 minutes—The default value is 30 minutes.
• Infinite—Inactive users are not logged out.
Failure to log out of iLO by either browsing to a different site or closing the browser also
results in an idle connection. The iLO firmware supports a finite number of connections.
Misuse of the Infinite timeout option might make iLO inaccessible to other users. Idle
connections are recycled after they expire.
This setting applies to local and directory users. Directory server timeout settings might pre-
empt the iLO setting.
Changes to the setting might not take effect immediately in current user sessions, but will be
enforced immediately in all new sessions.
iLO Functionality
Specifies whether iLO functionality is available.
When this setting is enabled (default), the iLO network is available and communications with
operating system drivers are active.
When this setting is disabled, the iLO network and communications with operating system
drivers are terminated.
To re-enable iLO functionality, use the UEFI System Utilities. For more information, see the
server maintenance guide.
iLO Web Interface
Specifies whether the iLO web interface can be used to communicate with iLO. This setting is
enabled by default.
iLO ROM-Based Setup Utility
To Next Page
Loading...
Need help?
General