151
Configuring the System Power Restore Settings
The System Power Restore Settings section enables you to control system behavior after power
is lost. You can also configure these settings by using the UEFI System Utilities during POST.
Prerequisites
Configure iLO Settings privilege
Procedure
1. Click Power & Thermal in the navigation tree.
The page opens with the Server Power tab selected.
2. Select an Auto Power-On value.
Changes to the Auto Power On value might not take place until after the next server
reboot.
3. Select a Power-On Delay value.
This value is not available if the Auto Power-On option is set to Always Remain Off.
4. Click Apply.
Auto Power-On
The Auto Power-On setting determines how iLO behaves after power is restored—for example,
when the server is plugged in or when a UPS is activated after a power outage. This setting is not
supported with micro-UPS systems.
Choose from the following Auto Power-On settings:
• Always Power On—Power on the server after the power-on delay.
To Next Page
Loading...
