173
General network settings
Use the iLO Dedicated Network Port or iLO Shared Network Port Network General Settings
page to configure the iLO Hostname and NIC settings.
Configuring the iLO Hostname Settings
Prerequisites
Configure iLO Settings privilege
Procedure
1. Click iLO Dedicated Network Port or iLO Shared Network Port in the navigation tree.
2. Click the General tab.
3. Enter the iLO Subsystem Name (Hostname).
The hostname is the DNS name of the iLO subsystem (for example, ilo instead of
ilo.example.com). This name can be used only if DHCP and DNS are configured to
connect to the iLO subsystem name instead of the IP address.
4. Enter the iLO Domain Name if DHCP is not configured.
To use a static domain name when the iLO Dedicated Network port is selected, disable the
Use DHCPv4 Supplied Domain Name and Use DHCPv6 Supplied Domain Name settings
on the IPv4 and IPv6 Network General Settings tabs.
To use a static domain name when the iLO Shared Network port is selected, disable the Use
DHCPv4 Supplied Domain Name setting on the IPv4 Network General Settings tab.
5. Click Submit.
6. If you are finished configuring the iLO network settings on the General, IPv4, IPv6, and SNTP
tabs, click Reset to restart the iLO processor.
It might take several minutes before you can re-establish a connection.
To Next Page
Loading...
Need help?
General