202
Boot Order
The Boot Order feature enables you to set the server boot options.
Changes made to the boot mode, boot order, or one-time boot status might require a server
reset. iLO notifies you when a reset is required.
An error occurs if you try to change the server boot order when the server is in POST. You cannot
modify the boot order during POST. If this error occurs, wait for POST to finish, and then try
again.
Configuring the server boot mode
Use the Boot Mode setting to define how the server looks for OS boot firmware. You can select
UEFI or the Legacy BIOS.
Prerequisites
Configure iLO Settings privilege
Procedure
1. Click Administration in the navigation tree, and then click the Boot Order tab.
2. Select Unified Extensible Firmware Interface (UEFI) or Legacy BIOS.
3. Click Apply.
iLO prompts you to confirm the change. When you change this setting, you cannot make
additional changes on the Boot Order page until you reset the server.
4. Click OK.
5. Reset the server.
Configuring the server boot order
Prerequisites
Configure iLO Settings privilege
Procedure
1. Click Administration in the navigation tree, and then click the Boot Order tab.
When Virtual Media is connected, the iLO web interface displays the Virtual Media type next
To Next Page
Loading...
Need help?
General