313
SSH issues
Initial PuTTY input slow with iLO
Symptom
During the initial connection to iLO through a PuTTY client, input is accepted slowly for
approximately 5 seconds.
Action
Verify that the client configuration options are correct.
Clear the Disable Nagle's algorithm check box in the low-level TCP connection options.
PuTTY client unresponsive with iLO Shared Network Port
Symptom
When you use a PuTTY client with the Shared Network Port, the PuTTY session becomes
unresponsive.
Cause
A large amount of data is being transferred or you are using a Virtual Serial Port and Remote
Console.
Action
1. Close the PuTTY client and restart the session.
An SSH session fails to start or terminates unexpectedly
Symptom
An SSH session fails to start or terminates unexpectedly.
Cause
iLO is configured to use the Shared Network Port, and NIC teaming is enabled for the NIC the
Shared Network Port uses. In this configuration, network communications might be blocked in
the following cases:
• The selected NIC teaming mode causes the switch that iLO is connected with to ignore
traffic from the server NIC/port that iLO is configured to share.
• The selected NIC teaming mode sends all traffic destined for iLO to a NIC/port other than
the one that iLO is configured to share.
Action
1. Ensure that your Shared Network Port configuration follows the NIC teaming guidelines.
To Next Page
Loading...
Need help?
General