283
Using the Server Health Summary
You can use iLO to display the Server Health Summary on an external monitor when the server is
powered on or off. This feature is useful for troubleshooting when the server will not start up,
and can also be used to view the server IP address and other health information.
Prerequisites
• The server has a UID button.
• An external monitor is connected.
Procedure
1. Press the UID button on the server.
CAUTION:
Press and release the UID button. Holding it down at any time for more than 5 seconds
initiates a graceful iLO reboot or a hardware iLO reboot. Data loss or NVRAM corruption
might occur during a hardware iLO reboot.
The Server Health Summary screen is displayed on the external monitor.
2. Press the UID button again to close the Server Health Summary screen.
Server Health Summary details
Server screen thumbnail
A thumbnail image of the server screen.
Server Power
To Next Page
Loading...
