282
data socket for iLO).
The ipport parameter is optional. The default port is 3002.
You can add other windbg command-line parameters if necessary. NEC Corporation
recommends using the -b parameter for the initial breakpoint.
11. Go to the server console (or access the iLO Remote Console), and press Enter to boot the
debug selection on the OS load menu.
This step might take several minutes.
12. When you are finished debugging the host server, use PuTTY to connect to the CLI and turn
off the debug socket to the Virtual Serial Port. Then, enter the following command:
windbg_disable.
You can disconnect and reconnect the Windows debugger as long as you keep the iLO
debug socket enabled.
To Next Page
Loading...
Need help?
General