55
Viewing the device inventory
The Device Inventory page displays information about devices installed on the system board.
Some examples of the devices listed on this page include installed adapters, PCI devices, SATA
controllers, and Smart Storage batteries.
If the server is powered off, the health status information on this page is current as of the last
power on. Health information is updated only when the server is powered on and POST is
complete.
The following information is displayed only if AMS is installed and running on the server:
Firmware version and status of add-in network adapters, network-attached storage details, and
Smart Storage Battery status.
If the iLO firmware cannot retrieve the network adapter product name or part number directly
from the device, it attempts to collect that information from AMS.
Procedure
1. Click System Information in the navigation tree, and then click the Device Inventory tab.
Device Inventory details
• Location—The device install location.
• Product Name—The device product name.
• Product Part Number—The device part number.
This column displays the value Various when the actual part number of the listed device
depends on internally installed graphics devices that differ by server model.
• Assembly Number—The device part number (NEC Corporation devices) or the EEPROM
Board Info data (third-party devices).
• Serial Number—The device serial number.
• Product Version—The device product version.
• Firmware Version—The installed device firmware version.
• Status—The device status.
To Next Page
Loading...
Need help?
General