262
Using the AMS Control Panel to configure SNMP and
SNMP alerts (Windows only)
Procedure
1. Open the Agentless Management Service Control Panel.
2. Click the SNMP tab.
3. Update the SNMP settings.
4. Optional: To generate a test alert and send it to the TCP/IP addresses in the Trap
Destination(s) boxes, click Send Test Trap.
Test alerts are used to verify the network connectivity of iLO with the Trap Destination(s)
addresses. After the alert is generated, check the alert destination for receipt of the alert.
5. To save the configuration, click Apply.
To Next Page
Loading...
