– 90 –
CHAPTER 4 OFFICE DATA DESIGN
Note: ACDTN, ACDPLT etc. need to be assigned other than the above.
Note 1: “CP” and “WAIT” are available when SYS1, INDEX449, b2=1.
Note 2: “MSGT” is not available when SYS1, INDEX449, b2=1. (Normally assign “0” with that data program-
ming)
Note 3: If values other than “0” are set to a parameter, an error will occur.
Note 4: RT No. is assigned by the AIVSL command.
Note 5: TRK No. is assigned by the AIVSL command.
To Next Page
Loading...
