– 363 –
CHAPTER 8 SYSTEM MAINTENANCE
3. SYSTEM MESSAGES
3.1 System Messages and Their Meanings
The system messages shown in Table 8-2 are displayed when faults occur with the ACD system. These tables
show the system messages in case faults and their meaning.
Table 8-2 System Messages for MIS
SYSTEM
MESSAGE
MEANING FAULT CONTENTS Page
4-R
TCP/IP Link Failure A fault has occurred to the UAP or to the
line connected with the external computer.
364
5-Q
ACD-MIS LOCK UP Something abnormal happened, and the
communication between ACDP and MIS
has been locked up. (To be displayed when
ASYD command, SYS 1, INDEX 42, b2 =
“1”.)
365
6-H
Bad Call Notification This message is issued to indicate the result
of Bad Call Notification.
366
26-V
LAN Interface Error
Report
A fault, related to the TCP/IP connection
between the Node and MIS/HOST,
occurred.
374
26-Y
Standalone Mode Set
Notification
This message is issued when the VNDM
Local node comes on-line as a Standalone
mode.
375
26-Z
Standalone Mode Release
Notification
This message is issued when the VNDM
Local node is released its standalone mode
and FCCS link is re-established.
376
To Next Page
Loading...
