– 285 –
CHAPTER 5 ACD SERVICE FEATURES FUNCTIONAL TEST PROCEDURES
NAP-215-114
Sheet 1/2
Night Service
Use one of the following three methods to change into the night mode.
(1) Automatic changeover into the night mode based on the ACD call control vector (Night Announce-
ment setting using ACD CCV command).
(2) Pressing the NIGHT key on the supervisory position of split C; as this display confirmation message
Night Mode?, enter 1# to change over into the night mode.
(3) Changeover into the night mode by means of operation at the MIS terminal of the supervisory
position.
Night Announcement
• Place a C.O. trunk call from station A to line B in the special night split.
Station A hears the night announcement.
Apply the test procedure above to all splits.
Using the ACD CCV command, change the night services of the split and test each of the following
services repeatedly.
Announcement
LC
A
B
COT
ATI
IP PAD
Split C
D: ATT
ELC/DLC
LC
A
B
COT
ATI
ELC/DLC
Announcement Trunk
Split C
D: ATT
Trunk
SP
LAN
For IP/SIP terminal For Digital terminal
To Next Page
Loading...
