NEC UNIVERGE SV7000 - TERMINAL SETUP; SETUP WITH UP;DOWN KEY

– 5 –
CHAPTER 1 INTRODUCTION
4. REGISTRATION DESTINATION OF IP DEVICES/STATIONS
Here lists IP addresses of Telephony Server to be assigned to each IP device/station as its registration destina-
tion. The IP address varies depending on several conditions, consisting of PH kind that handles the device/sta-
tion, protocol mode in which the device/terminal operates, and Telephony Server’s configuration. The table
below specifies the IP address necessary for each IP device/station, covering all the conditions.
Note: Device/terminal names in the table are general terms. If you want to know formal names of them, refer to
“TERMS IN THIS MANUAL” at the top of this manual.
Note: In this manual,Telephony Server may be referred as “DRS” or “SIP server” depending on the registration
destination. IP address of DRS/SIP server is, however, same as that of Telephony Server. Therefore, IP ad-
dress of DRS/SIP server is also as the table above.
Category
Device/Station
IP Address of
Registration Destination
CPU
Note 1
PH
Protocol
mode
Single
Configuration
Dual
Configuration
TP
Internal PHE
Proprietary
Protocol mode
Analog 2MC
MC&MG-COT (MC part)
IP-BS
VS32
LAN1 (ACT) LAN1 (ACT)
Internal PHI
Proprietary
Protocol mode
MC&MG-COT (MG part)
MG-COT
MG(BRI)
MG(PRI)
Note 2
MG(SIP)
LAN1 (ACT) LAN1 (ACT)
SP
MPH
SP-
PHD
Proprietary
Protocol mode
IP terminal LAN1 (ACT) LAN1 (ACT)
SIP mode SIP terminal
Note 3 LAN1 (ACT)
LAN1 (ACT)
/(System #0)
/(System #1)
SP-
PHI
Proprietary
Protocol mode
MC&MG-COT (MG part)
MG(BRI)
LAN1 (ACT) LAN1 (ACT)
SIP mode
MG-COT
MG(BRI)
MG(PRI)
MG-T1(SIP)
8LC Card
VS32
LAN1 (ACT)
LAN1
(System #0)
/(System #1)
-SIP mode
WLAN Handset (MH Series)
Standard SIP Terminal
LAN1 (ACT) LAN1 (ACT)