NEC UX5000 - Programmable Function Keys

ProgrammableFunctionKeys
Page-118
Programmable Function Keys
CustomizeyourterminalbystoringfeaturesoroutsidelinesunderyourProgrammableFunctionKeys.For
example,toreturnaMessageWaiting,justpressyourMessageWaitingfunctionkeyinsteadofdialing* 0.
To program a function key:
1. CALL1+8 5 1+FUNCTIONyouwanttoprogram.
2. Selectthe2-digitkeycodefromthefollowingchart.
OR
1. CALL1+8 5 2+FUNCTIONyouwanttoprogram.
2. Selectthe3-digitkeycode(*xx)fromthefollowingchart.
Akeypreviouslyprogrammedwith3digits(*xx)mustfirstbeundefinedbeforeitcanbe
programmedwitha2-digitcodeusingthe851servicecode.
WiththeDESI-Lessterminals,theLine/Loopkeyscanbedisplayedononeoffourdisplay
pages.Todisplaythepagewiththeringingline/loop,usetheScrollkeyontheDESI-Lesstouch
screentochangepages(however
,inmostcases,youcansimplyliftthehandsettoanswerthe
call).(Refertothepictureonpage170fortheScrollkeylocation.)
To check a stored function:
1. CHECK+FUNCTIONyouwanttocheck.
Theprogrammedfunctiondisplays.