NEC UX5000 - Dial Number Preview; Call

DialNumberPreview
Page-48
Dial Number Preview
UseDialNumberPreviewtopreviewanumberinyourterminal'sdisplaybeforeyoudialitout.Thishelps
youavoiddialingerrors.Forexample,ifyoureviewthepreviewednumberandfindanerror,youcancan-
celthenumberandre-enteritcorrectly.DialNumberPreviewisavailableforbothoutsideandIntercom
calls.
To use Dial Number Preview to place a call:
1. DonotlifthandsetorpressCALL1.
2. Dialthenumberyouwanttopreview.
IfVRSisinstalled,youwillneedtopress*thendialthenumbertobepreviewed.
3. CALL1todialoutthedisplayednumber.Ifthedisplayednumber isanoutsidenumber,itmustcontain
alineaccesscode.
OR
HOLDtocancelthenumberwithoutdialingitout.
OR
LINEtodialoutthedisplayedoutsidenumberontheselectedline.
Ifyourpreviewedoutsidenumberhasatrunkaccesscode(e.g.,9),youcanpressCALL1
instead.
TheUX5000willnotautomaticallystripoutatrunkaccesscodewhenyoupressalinekey.