NEC UX5000 - Conference; To Set up a Conference

Conference
Page-41
Conference
Conferenceletsyouaddadditionalinsideandoutsidecallerstoyourconversation.WithConference,you
cansetupamultiple-partymeetingwithoutleavingtheoffice.
InadditiontoConference,thereareotherwaystohaveameeting.SeeVoiceCall Conference(page42),
MeetMeConference(page79),MeetMePaging(page81)andTandemTrunking(page140).
To set up a Conference:
1. Placeoranswercall.
2. CONForFUNCTION(Conference).
3. Placethenextcall.
Toaccesstheoutsidecall,eitherpressLINE ordialatrunkaccesscode.SeeOutsideCallson
page103andpage105formore.
Ifthesecondcalltobeconferencedisringingin,placethefirstcallonhold,answertheringing 
call,thenfollowthestepsbelow.
4.
CONForFUNCTION(Conference).
Youmaybeabletohaveupto32callers.Repeatthissteptoaddmoreparties.
5. Afteraddingallparties,pressCONF againtobegintheConference.
Split(separate)theConferencecallsbypressingHOLD+894.
To exit a Conference (without affecting the other parties):
1. SPKtohangup.
YoucansetupaConferencewithtwooutsidecallersandthendropoutofthecall-leavingthe
callerstalkinginanUnsupervisedConference.RefertoTandemTrunkingonpage140formore.