NETGEAR GS310TP

Manage Device Security
265
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
• Match Every. Select one of the radio buttons to specify whether all packets must
match the selected IP ACL rule:
- Enable. All packets must match the selected IP ACL rule and are either permitted
or denied.
- Disable. Not all packets need to match the selected IP ACL rule.
• Interface. Select one of the radio buttons to specify whether all packets must be
mirrored or redirected:
- Mirror. From the menu, select the specific egress interface to which the matching
traffic stream must be copied, in addition to being forwarded normally by the
switch.
- Redirect. From the menu, select the egress interface to which the matching traffic
stream must be redirected, bypassing any forwarding decision normally
performed by the switch.
• Source IP Address. Enter an IP address using dotted-decimal notation to be
compared to a packet’s source IP address as a match criterion for the selected IP
ACL rule.
• Source IP Mask. Specify the IP mask in dotted-decimal notation to be used with the
source IP address value.
9. Click the Apply button.
Your settings are saved.
Modify the Match Criteria for a Basic IP ACL Rule
 To modify the match criteria for a basic IP ACL rule:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 11.
Your web browser might display a security message, which you can ignore. For more
information, see
Access the Local Browser Interface on page 19.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > ACL > Advanced > IP Rules.
The IP Rules page displays.