NETGEAR GS310TP

Monitor the System
303
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
transmitted packet, the copied packet is VLAN-tagged or untagged as it is being transmitted
on the source port.
 To globally enable port mirroring, specify the destination port, and specify one or
more source ports:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser
, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 11.
Your web browser might display a security message, which you can ignore. For more
information, see Access the Local Browser Interface on page 19.
The login window opens.
4. Enter the switch’
s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Monitoring > Mirroring > Port Mirroring.
6. Select an Admin Mode radio button:
• Disable. Port mirroring is disabled.
This is the default setting.
• Enabled. Port mirroring is enabled.
7. From the Destination Port menu, select the physical destination port to which port traf
fic
must be copied.