Newport MM4005 - Page 161

EDH0162En1040 – 06/99 3.78
MM4005 MX — Define X position for a
line segment = ƒ (MX, MY)
Usage  IMM  PGM  MIP
Syntax MXnn
Parameters
Description nn
[double] — X coordinate to reach with a line segment.
Range nn — -1.0 E
12
to 1.0 E
12
.
Units nn
— Preset units in SETUP mode.
Defaults nn Missing: Error C.
Out of range: Error C.
Description This command defines to the controller X position to reach with an ele-
ment of trajectory of the type:
Line segment = ƒ (MX, MY).
Returns None.
Errors C — Parameter out of limits.
S — Communication time-out.
V — Too long trajectory.
Y — Trajectory: Line (x, y). Line expected.
Z — Trajectory: Line (x, y). Too big discontinuity.
e — Trajectory: Units not translationnal or not identical.
Rel. Commands MY — Define Y position and build a line segment = ƒ (MX, MY).
XE — Tell the last element.
Example NT | Clear trajectory.
MX10 | Define X position of a line segment = ƒ (x, y).
MY10 | Define Y position an build a line segment = ƒ (x, y).
XE | Tell last element.
XE, Line (x, y), 10, 10, 45 | Controller tells the built element.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com