EasyManuals Logo

Newport XPS Programmer's Manual

Newport XPS
722 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #130 background imageLoading...
Page #130 background image
XPS Unified Programmer’s Manual
7.2.1.69 GroupAnalogTrackingModeDisable
Name
GroupAnalogTrackingModeDisable - Exits the analog tracking mode.
Input tests
- Refer to section 7.1: “Input Tests Common to all XPS Functions”.
- Valids group name: (-19)
- Group status must be “ANALOG TRACKING”: (-22)
Description
Disables the analog tracking mode.
The group exits the “ANALOG TRACKING” state returning to “READY” state.
If the group state is not “ANALOG TRACKING”, (-22) error is returned.
NOTES
The tracking mode interprets ADC value as a position command or as a velocity
command.
To enable the analog tracking mode use “GroupAnalogTrackingModeEnable function.
Prototype
int GroupAnalogTrackingModeDisable(
int SocketID,
char * GroupName
)
Input parameters
SocketID int Socket identifier gets by the
“TCP_ConnectToServer” function.
GroupName char * Group name.
Output parameters
None.
Return (In addition to the results of “Input Tests Common to all XPS
Functions”)
0: No error.
-9: Wrong number of parameters in the command.
-19: GroupName doesn't exist or unknown command.
-22: Not allowed action.
EDH0373En1023 01/18 116

Table of Contents

Other manuals for Newport XPS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Newport XPS and is the answer not in the manual?

Newport XPS Specifications

General IconGeneral
Controller TypeMulti-axis motion controller
Power Supply24 VDC
Communication InterfaceEthernet
Programming LanguageC, C++, .NET, LabVIEW
Supported Motor TypesStepper
Operating System CompatibilityWindows
AxesUp to 8 axes

Related product manuals