EasyManuals Logo

Newport XPS Programmer's Manual

Newport XPS
722 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
XPS Unified Programmer’s Manual
Close XPS Connection
if (m_xpsInterface != null)
m_xpsInterface.CloseInstrument();
3.4 How to Use XPS .NET Assembly from LabVIEW?
Refer to LabVIEW for more information on how to load and use a .NET assembly
depending on your LabVEW version.
3.4.1 Add Reference to .NET Assembly
Select CommandInterfaceXPS and XPS constructor from a .Net Constructor Node
(refer to Connectivity panel):
3.4.2 LabVIEW Code Sources
The instance of “XPS” object is created after configuration of .Net Constructor Node:
Open XPS connection (Use a .Net Invoke Node to select the XPS method
“OpenInstrument”):
7 EDH0373En1023 01/18

Table of Contents

Other manuals for Newport XPS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Newport XPS and is the answer not in the manual?

Newport XPS Specifications

General IconGeneral
Controller TypeMulti-axis motion controller
Power Supply24 VDC
Communication InterfaceEthernet
Programming LanguageC, C++, .NET, LabVIEW
Supported Motor TypesStepper
Operating System CompatibilityWindows
AxesUp to 8 axes

Related product manuals