XPS Unified Programmer’s Manual
7.2.1.155 PositionerCompensatedFastPCOPulseParametersSet
Name
PositionerCompensatedFastPCOPulseParametersGet – Sets pulse configuration to
compensated PCO.
Input tests
- Refer to section 7.1: “Input Tests Common to all XPS Functions”.
- Checks the positioner name: (-18)
- Checks pulses generation status: (-22)
- Checks if CIEFAST compensated PCO pulses generation is supported: (-115)
Description
This function sets values of parameters: Pulse width, Pulse polarity and Pulse toggle.
Prototype
int PositionerCompensatedFastPCOPulseParametersGet(
int SocketID,
char * PositionerName,
double PulseWidth,
int PulsePolarity,
bool PulseToggle
)
Input parameters
SocketID int Socket identifier gets by the
“TCP_ConnectToServer” function.
PositionerName char * Positioner name.
PulseWidth double * Width of pulse enable signal (units).
PulsePolarity int *.
PulseToggle bool *.
Output parameters
None.
Return (In addition to the results of “Input Tests Common to all XPS
Functions”)
• 0: No error.
• -8: Wrong object type for this command.
• -18: Positioner Name doesn't exist or unknown command.
• -22: Not allowed action.
• -115: Function is not supported by current hardware.
235 EDH0373En1023 — 01/18
To Next Page
Loading...
