Newport XPS Programmer's Manual

XPS Unified Programmer’s Manual
Output parameters
None.
Return (In addition to the results of “Input Tests Common to all XPS
Functions”)
• 0: No error.
• -5: Not allowed due to a positioner error or hardware status.
• -8: Wrong object type for this command.
• -18: Positioner Name doesn't exist or unknown command.
• -19: GroupName doesn't exist or unknown command.
• -22: Not allowed action.
• -35: Position is outside of travel limits.
• -50: Motor initialization error. Check InitializationAccelerationLevel,
ScalingAcceleration, MaximumJerkTime, EncoderResolution or
EncoderScalePitch.
• -113: Both ends of run activated.
EDH0373En1023 — 01/18 132

Newport XPS Specifications

General

Controller Type	Multi-axis motion controller
Power Supply	24 VDC
Communication Interface	Ethernet
Programming Language	C, C++, .NET, LabVIEW
Supported Motor Types	Stepper
Operating System Compatibility	Windows
Axes	Up to 8 axes