CLI Usage
102
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
rollback filename — the generic filename for rollback checkpoint files
rollback-sync
Syntax rollback-sync
Context admin>redundancy
Description This command copies all existing rollback checkpoint files from the active CSM compact flash
to the standby CSM compact flash on a 7705 SAR-8 or 7705 SAR-18. You can also enable
the system to save an automatic backup of each new rollback checkpoint file with the
rollback-sync command in the config>redundancy context.
Rollback checkpoint files can only be backed up from local sources and only by using the two
dedicated rollback-sync commands. The synchronize commands in the
config>redundancy and admin>redundancy contexts do not apply to rollback checkpoint
files.
Default n/a
rollback-sync
Syntax [no] rollback-sync
Context config>redundancy
Description This command enables automatic synchronization of locally saved rollback checkpoint files
between the active CSM and standby CSM.
When automatic rollback synchronization is enabled, a rollback save will cause the new
checkpoint file to be saved on both the active and standby CSMs if the rollback location is a
local location. The suffixes of all older checkpoint files on both active and standby CSMs are
incremented by one. Automatic synchronization only causes new rollback checkpoint files to
be copied to both CSMs. Any rollback checkpoint files that were created before
rollback-sync was enabled are not copied to the standby CSM. You can manually back up
all files using the rollback-sync command in the admin>redundancy context.
ipv6-address x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x - [0..FFFF]H
d - [0..255]D
interface: the interface name, 32 chars max, mandatory for
link local addresses
cflash-id cf3:|cf3-A:|cf3-B:
To Next Page
Loading...
