Boot Options
182
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
Default no address — there are no IP addresses assigned to CSM Management ports
Parameters ip-prefix/ip-prefix-length — the IP address for the CSM Management port
Values
active | standby — specifies which CSM Management port address is being configured:
the active CSM Management port or the standby CSM Management port
Default active
Caution:
• If you have a dual IPv4/IPv6 BOF address configuration and you are running a Telnet
IPv6 session or an SSH session, changing or deleting the active IPv4 address will not
affect the session.
• If you have a dual IPv4/IPv6 BOF address configuration and you are running a Telnet
IPv4 session or an SSH session, changing or deleting the active IPv6 address will not
affect the session.
• If you have a dual IPv4/IPv6 BOF address configuration and you change or delete the
active IP address that is the same version as the session (for example, you delete the
active IPv4 address while running a Telnet IPv4 session), the session will hang once
the change executes, and CLI access will be lost. You can either close the session (if
possible) or wait until it times out. You must start a new session, using the new or
existing active BOF address, to regain CLI access.
• If there is only one active BOF address on the port (that is, not the dual IPv4/IPv6
configuration), and it is deleted through a Telnet or SSH session, the session will hang
and CLI access will be lost. You must use a directly connected console session to
create a new BOF address. It is strongly recommended that you do not delete a single
active BOF address through Telnet or SSH.
ipv4-prefix a.b.c.d
ipv4-prefix-length 0 to 30
ipv6-prefix x:x:x:x:x:x:x:x (eight 16-bit
pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
ipv6-prefix-length 0 to 126
To Next Page
Loading...
