System Management
360
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
broadcast-client
Syntax [no] broadcast-client
Context config>system>time>sntp
Description This command enables listening to SNTP/NTP broadcast messages on interfaces with
broadcast client enabled at global device level.
When this global parameter is configured, then the ntp-broadcast parameter must be
configured on selected interfaces on which NTP broadcasts are transmitted.
SNTP must be shut down prior to changing either to or from broadcast mode.
The no form of the command disables broadcast client mode.
Default no broadcast-client
server-address
Syntax server-address ip-address [version version-number] [normal | preferred]
[interval seconds]
no server-address ip-address
Context config>system>time>sntp
Description This command creates an SNTP server for unicast client mode.
Parameters ip-address — specifies the IP address of the SNTP server
version-number — specifies the SNTP version supported by this server
Values 1 to 3
Default 3
normal | preferred — specifies the preference value for this SNTP server. When more
than one time-server is configured, one server can have preference over others. The
value for that server should be set to preferred. Only one server in the table can be
a preferred server.
Default normal
seconds — specifies the frequency at which this server is queried
Values 64 to 1024
Default 64
To Next Page
Loading...
